Tungsten carbide valve seats have been widely used in industrial fields due to their excellent wear resistance, corrosion resistance and high strength. However, in order to ensure its performance and longevity, the following points need to be paid attention to during use.
First of all, the installation needs to be correct. When installing carbide seats, it must be carried out in strict accordance with the operating procedures. Make sure the fit between the seat and body is tight to avoid gaps or loosening. Care should be taken during installation to prevent damage to the valve seat. At the same time, it is necessary to ensure that the valve is installed in the correct position so that the valve seat can function normally.
Secondly, the operation should be standardized. When using the valve, it should be avoided to open and close the valve with excessive force to avoid shocking the valve seat. It should be used in accordance with the specified operating pressure and temperature range, and should not exceed the bearing limit of the valve seat. When opening and closing the valve, it should be done slowly to avoid damage to the valve seat caused by water hammer.
Furthermore, maintenance should be timely. Inspect and maintain the valve regularly to see if the seat is worn, corroded, or damaged. If a problem is found, it should be repaired or replaced in a timely manner. When cleaning valves, use suitable cleaning agents and avoid using highly corrosive chemicals that can damage the seat surface.
Also, store it properly. When the valve is not in use, it should be stored properly. Store the valve in a dry, ventilated place away from direct sunlight and humid environments. At the same time, it is necessary to prevent the valve from being bumped and crushed to avoid damaging the valve seat.
Post time: Sep-30-2024